Andrew made up a template of the floor of the Willy's for Dylan to use so there would be no unecessary loss of expensive sheet-metal . . .
Quick check to see that all bases are covered. . .
And it's of to the guillotene and then a session with the grinderand some cutt-off wheels then all that's left is to weld the new floor into place. Sounds simple but there's a few hours work involved and just a little bit of experience helps too!. . .
While I was busy with 'Grand-daughter Wednesday' the boys fitted out the rear space with a new sheetmetal boot space. Not much room left after fitting the new disc brake rear end and then a 4inch body drop . . .
No comments:
Post a Comment